Waterjet cutting glass belongs to cold cutting. The waterjet can cut arcs and sharp corners, and can cut any complicated patterns on the plane. It is fully numerically controlled, high in efficiency and good in quality. It is generally used on craft glass. And it can be punched without opening when cutting. The cut surface is ideal. When cutting glass with a water jet, the normal water jet pressure is 260-280MPA. If the pressure is too high, it will cut the glass and cause edge chipping. The selection of cutting speed should be set according to the cutting surface, generally the best speed is vertical cutting surface. In the glass cutting process, the cutting edge cannot be the edge of the glass, try cutting from the outside of the glass. After smoothing, cut to the edge of the glass, and then throw it down if it is not possible with a manual edging machine.
         When we use waterjets to cut holes or other shapes, the size of the glass is not large, but we can only cut one piece of glass at a time. The time spent on the upper and lower sheets is much longer than the actual processing time. Is there any way to Processing multiple pieces at once, shortening the auxiliary time? This problem can be solved as follows: If the glass is not big, you can make 2-4 stations on your work surface when doing CAD drawings, that is, your machine is 4000X2000, and your product only needs 1500X1000 space. You can make 4 processing drawings at a time, and put 4 pieces of glass at the same time (the glass cut corners are uniform, and the size is the same), and block the glass for the glass alignment (turn off the electronic eye alignment), so that the machine is processing the glass behind At that time, you can carry out the loading and unloading, but there is a safe operation with the back, it is best to install a pull cord emergency stop switch on the table.