When the water cutting machine is used, the normal pressure water should be increased to more than 200 MPa through the supercharger, and then the pressure energy of water should be converted into kinetic energy through the small hole of an energy converter, and the abrasive should be added, so that the abrasive can accelerate under the drive of high-speed water flow and then shoot at the object to form a great cutting ability.
         With the popularization of cutting equipment, the cutting advantage of water cutting machine is more and more obvious, so the use of water cutting equipment industry is also increasing. It is understood that the water cutting machine is not only commonly used in the cutting and processing of materials, but also can play an important role in carving fine patterns.
         Compared with other cutting equipment, the water cutting machine increases the smooth effect of the plate and the ability to control the rotating speed of the mechanical and electrical equipment. Therefore, when it is in a particularly delicate manual carving, it can complete any cutting pattern on time and ensure good cutting quality.
         When the water cutting machine is actually carving fine patterns, it can also avoid the loosening of the cutting, which increases the firmness of the mixed components in the water cutting process. Especially in the modification of professional ceramic technology, the use of water cutting machine increases the beautiful effect of hand-made glass products.
         This is mainly because when the water cutting machine works, it can avoid the large gap flow of ceramics, and effectively improve the sharp effect in the environmental protection cutting process, so to a certain extent, it greatly improves the carving quality and precision of fine patterns.
         However, it should be noted that when facing different purposes, the water cutting machine needs to adjust its pressure reasonably according to the material properties and requirements. As a kind of equipment to cut materials by producing high-pressure water jet by pressurizing water, the cutting pressure of materials with different hardness and thickness is also different.
         The water jet of the water cutting machine starts from the pressure pump, passes through the high-pressure pipe, and then shoots out from the cutting nozzle. Although this is a very simple explanation, but it is through a very complex design, to produce the pressure required for cutting, this cutting process is actually a grinding and cutting process, this force and action are generated by water.
         During the cutting process of the water cutting machine, it is impossible to be smooth. Sometimes the sand valve will break the sand. At this time, check the negative pressure gauge. If the negative pressure is obviously lower than the set value, there may be accumulated impurities in the throttling end of the nut at the outlet of the sandbox.
         In this case, you can directly open the nut of the welded pipe joint and put down the sand control valve; then use a screwdriver to remove the throttle valve seat, and the general impurities will flow out with the garnet sand. If it still can't work, it may be because there are too many or too many accumulated sundries, so it is necessary to remove the sandbox to remove the sundries.
         If there is no negative pressure on the negative pressure gauge of the water cutter, it is generally caused by foreign matters or excessive garnet sand accumulated between the sand control valve body of the water cutter and the joint of the sand conveying pipe. The cleaning procedure of Henan CNC water cutting machine in this case is more complicated. It is necessary to remove the joint of sand valve, sand pipe and sand pipe one by one; then clean it with high-pressure gas, so that the equipment can return to normal.